Category: Mission Rock G System for Schucal

Changes: New rules for bottom outer frame and rebate profile for balcony door insert. Create/Open Mission Rock G unit and as Mullion profile choose 9643385 Hint: To add new mullion please select the infill and right click > Split areas. As Number of widths set 2 (or more, if you need more mullion divisions), as Number of heights set 1...

Changes: Mullion 9643385 added. Various intersection configurations between mullion and transoms defined Create/Open Mission Rock G unit and as Mullion profile choose 9643385 Hint: To add new mullion please select the infill and right click > Split areas. As Number of widths set 2 (or more, if you need more mullion divisions), as Number of heights set 1 (or more,...

Changes: Louver transom 9643381 added. Create/Open Mission Rock G unit and as Transom profile choose 9643381 Hint: To add new transom please select the infill and right click > Split areas. As Number of widths set 1, as Number of heights set 2 (or more, if you need more transom divisions).

Changes: Installer recompiled for Schucal 2021

Changes: Added 2mm deduction for each 9643384 glass support perimeter profile.

Changes: 9643386 transom added. Use tool Draw sub-division or Split area to construct the transom. Glass panel and gaskets removed from the model.

Changes: Unit reference points transferred to rough opening. Please define RO dimensions as the unit size to get correct frame size.

Changes: Unit reference points transferred to front surface of glazing support.

Changes: Minor changes

Procedure after installation: Start/Restart SchuCal Create new unit Choose the unit type under System templates > 10 – Custom Systems USA > Mission Rock G > Corner unit or Single unit On the right pane choose system Mission Rock G – Change the corner type to any of possible 90°, 78° and 102° by entering this angle to Angle2 field...